Showing all 3 results
Silicone Mold Softener
£5.75 – £101.00(0 Reviews)
Product is skin and food safe
For the platinum Catalyst system this can be added either liquid, however for the silicone tin catalyst system it should be added to base paste not the catalyst.
Use: to soften silicone molds. Only a small quantity is required.
Adding above 5% will start retarding the reaction giving a longer pot life and cure time
Tin/Condensation Cured Silicone- guide
1ml added to 100ml base paste hardness reduced by 10%
3ml added to 100ml base paste hardness reduced by 30%
5ml added to 100ml base paste hardness reduced by 50%
Platinum/Addition Cured Silicone
5ml added to 100ml base paste hardness reduced by 9%
10ml added to 100ml base paste hardness reduced by 18%
15ml added to 100ml base paste hardness reduced by 25%
£5.75 – £101.00
Silicone Release Wax
£5.90 – £11.50(0 Reviews)
Wax in a solvent carrier liquid.
For use as surface coating/sealant of porous surfaces prior to taking a two part silicone molds.
It allows for easy release of silicone impression mold . When casting resin into a silicone mould using a release agent will help prolong life of mold.
Directions:
Apply one to two coats allowing each coat to dry before applying the next
More coats may be required for Porous materials such as wood, concrete and plaster etc
Apply with a brush, or standard air gun/air brush or dip the item in the liquid.
£5.90 – £11.50
Silicone Thixotrophic agents
£3.60 – £6.00(0 Reviews)
Silicone thickening liquid
Silicone thickening liquid
This product is suitable for both condensation/tin and addition/platinum silicones.
It is a very potent thixotropic (thickening) effect, typically in the range of 0.1-3% is required to get the desired consistency. Consistency can range from viscous material for use with a brush or gel type for use with a spatula or hand.
When used with tin/condensation cure silicone it can be added both before or after addition of the catalyst.
It is recommended you adjust the viscosity of silicone fluid before adding the catalyst so that pot life is not affected. Intially unthickened material should be applied to mold taking care not to trap air. This will capture fine details of mold. Then more thickened material can be added to fill up mold. Ensure first layer is still wet before applying adding rest.
.
£3.60 – £6.00
